Pneumatic Pipe Cutting Machine For Rubber Pneumatic Slicer For Plastic Cutter

Pneumatic Pipe Cutting Machine For Rubber Pneumatic Slicer For Plastic Cutter

Introduction:

Pneumatic slicer(cutter) is suitable for cutting samples of rubber, plastic, leather or various composite materials in the laboratory, dumbbell test pieces for testing, and other special materials. It can also be used as a small press.

Specification:

1. Load: 1000KG.

2. Platen diameter: Ф120 mm.

3. Base plate: 230X250mm.

4. Effective height: 100mm.

5. Machine size: 280X330X430mm.

6. Machine weight: about 20 kg.

Operation:

1. Place the machine on a flat surface, adjust the four feet to make it stable.and put the cutting glue.

2. Open the ventilation source, adjust the rear oil-water separator valve switch, adjust the barometer to at least 4KG.

3. Put the PU glue, put the film on the glue, then put the knife mold, then hold the red button switch at the same time with both hands (for safety, both hands must be pressed at the same time), press the plate down on the knife mold, stay for a few seconds, so that the rubber is fully cut off, and at the same time let go, take out the test piece.

4. When you are finished, please turn off the air supply.